Enable Basic Metrics on Azure - Manually

Document created by fadi.josef Expert on May 29, 2017Last modified by umar.adams on Aug 15, 2017
Version 4Show Document
  • View in full screen mode

In this document, we will be looking at how we can enable Basic Metrics on Azure. This document will cover how to do this manually. If you don't have Basic Metrics enabled then Azure will not be collecting Memory Stats and Turbonomic will not be able to pull this information from Azure.

 

Step 1: Login to your Azure Portal (http://azure.portal.com)

Step 2: If you are creating a new VM then make sure you have "Guest OS diagnostic" Enabled.

 

 

If you have previous VMs then follow the steps mentioned below.

Step 3: Select the VM you would like Turbonomic to Monitor Memory Metrics for.

Step 4: Select "Diagnostic Settings"

 

 

Step 5: 

  • For Windows VMs

 

  • For Linux VMs
    • Select Diagnostics settings
    • Make sure the Status is On 
    • Storage account: - Select your storage account so that the metrics stats can be stored
    • Make sure the Basic metrics option is checked

After you enable Basic metrics the Save button should be enabled so you can save the settings. The screenshot below shows an example of how it will look after enabling basic metrics.

After you enable Basic Metrics you will be able to see a lot more Metrics on the Metrics sections.

 

Step 6: Double check the DateTime value in the Turbonomic VM  

  • There have been a few situations where an out-of-sync clock on the Turbonomic VM can prevent vMemory utilization values from being populated as a result of not being able to communicate with the Azure Storage Account. To clarify, when we say "out-of-sync clock" we just mean that the actual time that the Turbonomic VM knows should match up (+/- 2 min) with the timezone it is configured to.
  • To confirm that the clock is in sync, open a PuTTY session to the Turbonomic VM and type in the "date" command. This will return the date, time and timezone that the VM knows:

 

  • Again, make sure that the time value (in this case it is 9:20 AM) matches up with the timezone recognized (in this case EDT). The above example is from a properly synchronized clock, however if the time value returned was 9:00 AM, then this clock would be out sync with the EDT timezone it is set to and needs to be reconfigured.
  •  To resolve/avoid these issues, just sync up the Turbonomic VM with an NTP server or use the OpenSuse yast command to manually adjust the clock.
2 people found this helpful

Attachments

    Outcomes